Crestron C2N-NPA8, Руководство по эксплуатации

Страница: 17 / 40

Crestron C2N-NPA8 Network Poll Accelerator
Wiring Power Connectors on C2N-NPA8 with CNPWS-75 Power Supply
C2N-NPA8
CNPWS-75
To Control System via TCP/IP
or Serial Communications
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
NOTE: If a Cresnet device connected to a powered segment has its own power
source, remove the 24V line from the Cresnet connector on the C2N-NPA8.
Although equipment damage is unlikely, Crestron does not recommend applying two
power sources to the same segment.
Communication Connections
When using a PC for console operations on the C2N-NPA8, refer to “Establish a
Serial Connection” on page 14.
The C2N-NPA8 can also be connected to compatible control systems that are
equipped with an Ethernet port. Refer to “TCP/IP Communications Between a
Control System and the C2N-NPA8” on page 14.
NOTE: For a list of control systems that are compatible with the C2N-NPA8, refer
to “Compatible Control Systems” on page 6.
C2N-NPA8-Control System Communications
The C2N-NPA8 can communicate with a control system over serial or TCP/IP
communication. Only one method of communication can be used.
Serial Communications Between a Control System and the
C2N-NPA8
If a direct connection from a PC to the C2N-NPA8 is required for uploading
firmware or performing diagnostics, follow the steps described in “Establish a Serial
Connection” on page 14. If the C2N-NPA8 firmware is to be upgraded through a
connection to a control system, refer to “Uploading and Upgrading” on page 22.
Operations Guide – DOC. 6087A Network Poll Accelerator: C2N-NPA8
•
13