Crestron C2N-NPA8, Руководство по эксплуатации

Страница: 20 / 40

Network Poll Accelerator Crestron C2N-NPA8
C2N-NPA8 IP Table
4. Click Add and enter the IP ID and IP address/Hostname of the control
system in the relevant fields. Set as Master must be checked to indicate
that the C2N-NPA8 is controlled by the device using the IP address.
Select
Connect Using TCP and click OK.
NOTE: The “IP Table Setup” window allows more than one entry to be entered in
the C2N-NPA8’s IP table. However, the poll accelerator will only read the first
entry. All other entries will be ignored.
5. Click Send to send the IP table to the C2N-NPA8. If an entry does not
already exist, add a corresponding entry for the C2N-NPA8 in the
control system’s IP table.
6. Create an entry in the control system’s IP table listing the IP address of
the C2N-NPA8.
NOTE: Port number 41791 must be accessible to the control system for
communication with the C2N-NPA8.
NOTE: If a control system program uses a TCP/IP Client symbol or TCP/IP Server
symbol, port number 41791 cannot be specified for either symbol if a C2N-NPA8 is
in the control system program.
NOTE: The default port number assigned by Viewport should not be changed when
configuring the IP tables on the control system and the C2N-NPA8.
NOTE: If an IP table is defined in the C2N-NPA8, then serial communication
between the C2N-NPA8 and a control system is disabled. To enable high-speed
serial communications, remove the IP table entry from the C2N-NPA8’s IP table.
TCP/IP communications between the C2N-NPA8 and the control system will be
disabled while serial communication will be enabled.
Once the IP settings have been defined in the IP tables of the C2N-NPA8 and the
control system, the C2N-NPA8 can communicate with the control system using a
TCP/IP connection.
16
•
Network Poll Accelerator: C2N-NPA8 Operations Guide – DOC. 6087A