Creo iqsmar series, Руководство по установке и обслуживанию

Страница: 51 / 200

Startup Sequence 37
4.2 Startup Sequence
¾
Power ON the scanner (the main power switch on the back of the
scanner), then press the Power button on the Operating panel to
switch the scanner ON.
When you switch ON the scanner, the Power LED on the operating
panel is green. During the diagnostic self-tests, the Status LED
illuminates according to various stages, as follows:
• The Status LED is orange for several seconds when the scanner
is switched ON.
• The Status LED turns OFF for several seconds while the
scanner checks the firmware.
•
The Status LED turns green .
4.3 Startup Troubleshooting
If the startup sequence is not completed successfully, one of the
following events will occur:
•
The Status LED remains red (possible hardware fault).
• The Status LED remains blinking red and the Power LED is red
because one of the safety switches was activated.
•
The Status LED remains orange (missing firmware, which may be
loaded after launching the Calibration program or the Installation
and Utilities program).
It is recommended to continue with the installation procedure even if
one of these events occurs. If the installation procedure is terminated
and cannot be continued, contact your service center.
For iQsmart3 only : The Status button on the Operating panel is used to switch
the light table ON and OFF when the top cover of the scanner is open.
For details, see Chapter 10 General Troubleshooting on page 125 .