Creo iqsmar series, Руководство по установке и обслуживанию

Страница: 119 / 200

Lamp Unit Replacement 105
7.
Carefully remove the unit by pulling it to the left.
8. Carefully insert a new transparency lamp unit. Insert the two holes
on the sides of the lamp unit into the two guide pins in the lamp
unit holder.
9.
Tighten the lock screw on the side of the lamp unit.
10. Connect the lamp unit connector.
11. Remove the foam you placed on the base glass in step 3.
12.
Lift up the plastic frame back to its proper position, and tighten the
five screws that secure it by pressing and rotating them 90°
clockwise. Make sure to tighten the screws properly.
13.
Remove the cardboard you placed on the glass plate in step 1.
14. Power ON the scanner (the main power switch is on the back of the
scanner), then switch the scanner ON by pressing the Power
pushbutton on the Operating panel.
15.
Verify that the new lamp illuminates after a few seconds.
Make sure not to touch the lamp unit window that faces down.
Open
Close