Creo Dolev 800V+, Руководство пользователя

Страница: 52 / 90

42 Chapter 3 – Media Management
6.
Twist the
inner
rim of the
removable
flange and, using the supplied
tool, remove it from the spool.
7.
Place the new roll of film on the table.
Note the film position
: rolled away from the cassette, emulsion down.
Figure 16: Removing the Film Spool
8.
Grasp the spool by the
fixed
flange, and insert the spool through the
film roll (film emulsion down).
9.
Place the
removable
flange onto the spool, and twist it to tighten it on
the spool.
10.
Lower the spool into the cassette, so that its ends fit between the
prongs of the cradle. Allow approximately 1 inch of film to stick out,
over the edge of the cassette.
11.
Check that the film is straight (that is, parallel to the cassette lid), and
shut the cassette lid.
12.
Lead film cutter (supplied) can be used to trim the film to the
required length.
Note: If the cassette contains a film roll, remove it from the spool. Place any
unexposed film in a film case or container, and mark it.
2. Remove mounting
flange from spool
1. Open supply
cassette lid
3. Place film roll
emulsion side
down
Note: If too much film sticks out, cut the excessive part (do not push it back).