Crena CY658, Инструкция по эксплуатации, Страница: 9 / 21

• Before filling the water tank with water, remove the mains
plug. Do not fill more than 0,7 litre of cold water into the
water tank.
• Do not bend the connecting hose (4)!
• Only clothes are to be ironed with this machine!
• Please use only distilled water. Do not use any
decalcification agents! These will destroy the machine!
First Use of the Machine
• Clean the ironing base with a slightly damp cloth. Remove
any foil from the sole of the iron.
• In order to remove all residues before initial use, please
pass the iron a few times over an old clean cloth.
• Open the seal (7) of the water tank and fill it through the
opening with not more than 0.7 litres of pure distilled water.
Then re-tighten the seal.
• Do not fill battery water, water from the clothes dryer and
water containing additives (such as starch, perfume,
softener or other chemicals) into the water reservoir. This
could damage the iron due to residues forming in the steam
chamber. These residues may cause impurities to the fabric
when dropping out of the holes in the soleplate.
USING THE MACHINE
IRONING WITHOUT STEAM
1. Sort out the garments according to their ironing
temperatures.
2. Always turn the temperature control to the lowest
temperature setting (before the setting “_”) before
connecting the device to or disconnecting it from the mains.
3. Start with the lower temperatures. It is set with the
thermostat (1):
• Synthetics, silk low temperature
• • Wool medium temperature
• • • Cotton, linen high temperature
MAX maximum temperature
4. Place the iron on its stand.
5. Electrical connection:
• Make sure that the iron voltage (see name plate) and the
line voltage match.
• Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.