Crena CY658, Инструкция по эксплуатации, Страница: 10 / 21

6. Turn operating switch I (10) on the station to position 0
and move the steam regulator (9) to MIN. Please ensure
that operating switch II (11) is turned to position I.
Operating switch II (11) lights up.
7. The control lamp of the iron (5) shows it is being heated
up. As soon as the control lamp goes off the operating
temperature has been reached. Now you can start ironing.
8. Always remove the mains plug after using the machine.
Steam Ironing
For this a high temperature is needed.
1. In the warm-up phase the control lamp goes on (12).
2. Turn the temperature control (1) to position
• • • (cotton, linen).
3. Move both operating switches (10/11) to position I.
During operation the control lamp (12) shows whether there
is enough steam available for steam operation.
On = enough steam available
Off = steam being produced (The control lamp (13) also
lights up briefly.)
Warning: The steam is hot! There is a danger of scalding!
You can set the desired quantity of steam with the steam
regulator (9).
With the steam jet button (2) you can produce a short
strong jet of steam.
Continuous steam is produced by locking the catch (3) in
place.
FILLING IN WATER DURING OPERATION
1. The control lamp (13) lights up when the water tank is
empty.
2. The water tank can be replenished with water. First turn
operating switch I (10)
to 0. Operating switch II (11) remains switched to I.
Note: If there is still some residual pressure in the water
tank, a safety lock prevents the water tank catch (7) from
being opened. The residual pressure first has to be relieved
before the device can be safely opened.
3. With the steam jet button you can now release the
residual steam pressure.
When no further steam comes out of the iron sole plate,
turn operating switch
II (11) to 0. Then please remove the mains plug and
carefully open the water tank lock (7).