XLAMP
®
MH FAMILY LED SOLDERING & HANDLING
© 2014-2021 Cree LED. The information in this document is subject to change without notice. Cree
®
and the Cree logo are registered trademarks, and
the Cree LED logo is a trademark, of Cree, Inc. XLamp
®
is a registered trademark of Cree LED. Other trademarks, product and company names are
the property of their respective owners and do not imply specific product and/or vendor endorsement, sponsorship or association. This document is
provided for informational purposes only and is not a warranty or a specification. For product specifications, please see the data sheets available at
www.cree-led.com.
CLD-AP193
REV 4
9
XLAMP
®
MH FAMILY LED REFLOW SOLDERING CHARACTERISTICS
IIn testing, Cree LED has found XLamp MH Family LEDs to be compatible with JEDEC J-STD-020C, using the parameters listed below.
As a general guideline, Cree LED recommends that users follow the recommended soldering profile provided by the manufacturer of the
solder paste used, and therefore it is the lamp or luminaire manufacturer’s responsibility to determine applicable soldering requirements.
Note that this general guideline may not apply to all PCB designs and configurations of reflow soldering equipment.
Profile Feature
Lead-Free Solder
Average Ramp-Up Rate (Ts
max
to T
p
)
1.2 °C/second
Preheat: Temperature Min (Ts
min
)
120 °C
Preheat: Temperature Max (Ts
max
)
170 °C
Preheat: Time (ts
min
to ts
max
)
65-150 seconds
Time Maintained Above: Temperature (T
L
)
217 °C
Time Maintained Above: Time (t
L
)
45-90 seconds
Peak/Classification Temperature (Tp)
235 ‑ 245 °C
Time Within 5 °C of Actual Peak Temperature (tp)
20-40 seconds
Ramp-Down Rate
1 ‑ 6 °C/second
Time 25 °C to Peak Temperature
4 minutes max.
Note: All temperatures refer to topside of the package, measured on the package body surface.
Note: While the high reflow temperatures (above) have been approved, Cree LED’s best practice guideline for reflow is to use as low a
temperature as possible during the reflow soldering process for these LEDs.
IPC/JEDEC J-STD-020C
T
P
T
L
Temper
atur
e
Time
t 25˚C to Peak
Preheat
ts
t
S
t
P
25
Ramp-down
Ramp-up
Critical Zone
T
L
to T
P
Ts
max
Ts
min
