3
CPWR-AN17, Rev -, 05-2016
Copyright © 2016 Cree, Inc. All rights reserved.
The information in this document is subject to change without notice.
Cree, the Cree logo, and Zero Recovery are registered trademarks of Cree, Inc.
CAUTION
DO NOT TOUCH THE BOARD WHEN IT IS ENERGIZED AND ALLOW THE BULK
CAPACITORS TO COMPLETELY DISCHARGE PRIOR TO HANDLING THE
BOARD. THERE CAN BE VERY HIGH VOLTAGES PRESENT ON THIS
EVALUATION BOARD WHEN CONNECTED TO AN ELECTRICAL SOURCE, AND
SOME COMPONENTS ON THIS BOARD CAN REACH TEMPERATURES ABOVE
50˚ CELSIUS. FURTHER, THESE CONDITIONS WILL CONTINUE FOR A SHORT
TIME AFTER THE ELECTRICAL SOURCE IS DISCONNECTED UNTIL THE BULK
CAPACITORS ARE FULLY DISCHARGED.
Please ensure that appropriate safety procedures are followed when operating
this board, as any of the following can occur if you handle or use this board
without following proper safety precautions:
● Death
● Serious injury
● Electrocution
● Electrical shock
● Electrical burns
● Severe heat burns
You must read this document in its entirety before operating this board. It is not
necessary for you to touch the board while it is energized. All test and measurement
probes or attachments must be attached before the board is energized. You must
never leave this board unattended or handle it when energized, and you must always
ensure that all bulk capacitors have completely discharged prior to handling the
board. Do not change the devices to be tested until the board is disconnected from
the electrical source and the bulk capacitors have fully discharged.
警告
请
勿在通
电
情况下接触板子，在
处
理板子前
应
使
大容量
电
容器完全
释
放
电
力。
接通
电
源后，
该评
估板上可能存在非常高的
电压
，板子上一些
组
件的温度可能超
过
50
摄
氏度。此外，移除
电
源后，上述情况可能会短
暂
持
续
，直至大容量
电
容器完全
释
放
电
量。
操作板子
时应
确保遵守正确的安全
规
程，否
则
可能会出
现
下列危
险
：
