8
IF WATER IS TOO COLD
Turn Knob “E”
anti-clockwise
“1/8” of a
turn, and continue turning anti-clockwise until
you get the water temperature of your liking.
Wait 20 seconds
after each adjustment for
the water temperature to stabilise.
The final adjustment may be in any position.
If after turning fully anti-clockwise water is
still too cold, set shower pattern on shower
handset to outer or inner pattern only.
IF WATER IS TOO HOT
Turn
Knob “E” clockwise
“1/8” of a turn, and
continue turning clockwise until you get the water
temperature of your liking.
Wait 20 seconds
after each adjustment for the
water temperature to stabilise.
The final adjustment may be in any position.
If after turning fully clockwise, water is still too hot,
press Button “B” (
II
-
medium) and re-adjust Knob
“E” to give desired temperature.
Water flow will be reduced on this setting.
1.
Ensure the electricity and water are turned on to the unit.
2.
Your shower can be turned on by pressing either
Button “A”
,
Button “B”
or
Button “C”
(see Diagram 5).
Button “A” (
III
) -
Starts shower on “
High”
power.
Button “B”
(
II
)
- Starts shower on “
Medium
” power.
Button “C”
(
I
)
- Starts shower on “
Cold
”.
Once pressed, a light will illuminate above the button
confirming that power selection has been made.
Knob “E”
controls the temperature of the water, and
For this example turn Knob “E” to “mid-position”.
3.
Press Button “A”
and the water will flow.
4.
Allow about 20 seconds for the temperature of the water to stabilise.
It is recommended that you do not wholly enter the water spray
during this period, even if the shower has just been used.
5.
Once a temperature setting to your liking has been achieved, Knob “E” will rarely need adjusting.
You must however take into account required adjustments for variations of incoming mains water
temperature between summer and winter (see “Effect of Seasonal Incoming Water Temperature
Changes” page 10).
6.
When you have
finished
showering,
press button “D”
( ) only, the LED light above will flash.
Water will continue to flow for up to 7 seconds before switching off.
Wait for the water to stop, and then switch off the electricity at the ceiling switch or local isolator.
7.
Turning the shower on by pressing
Button “B”
reduces the power used by the shower giving a
cooler shower or the option of reduced water flow.
This option is mainly for summer usage and if this is used then
Knob “E”
must be re-adjusted.
8.
Turning the shower on by pressing
Button “C”
will supply water without any heating
.
9.
Your shower is
designed to stabilise temperature
changes caused by water pressure fluctuations
(see “Effect of Other Water Devices on Incoming Water Supply” see page 10).
WARNING: DO NOT SWITCH THE SHOWER ON IF YOU SUSPECT IT OF BEING FROZEN.
WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.
WARNING: DO NOT OPERATE THE SHOWER IF WATER IS DISCHARGED FROM THE
PRESSURE RELIEF VALVE. MAINTENANCE IS REQUIRED BEFORE THE SHOWER
CAN BE SAFELY USED
.
WARNING: CONSIDERATION SHOULD BE GIVEN TO SUPERVISING THE YOUNG, ELDERLY
AND THE INFIRM WHILST THEY USE THIS SHOWER.
HOW TO USE YOUR
SPA300C
SHOWER (DETAILED)