Cutter’s Mate
Owner’s Manual
10 van 14
Cuttersmate-europe 2012 Rev. 1
End Blocks
The arm will glide more smoothly along the slide shaft if the end blocks are placed against the spring and
the silver shaft collar (see page 6).
It may be necessary to move the end blocks closer together on the slide shaft to meet your personal needs
(usually to fit a smaller surface or grid).
Use a hex wrench to loosen the set screw on the black shaft collar. Slide the collar to the desired position
and retighten the set screw.(see picture below)
IMPORTANT:
The black shaft collar is made to tighten around the shaft, whereas the silver shaft collar is
held in place by a screw making contact to the shaft. Therefore repositioning the
silver shaft collar
(
do not
do this
) will create marks on the shaft which could hinder movement of the nylon bushings
.
