Model No.
CRT-571
SPECIFICATION
Date 2010/01/10
Ver. 1.0
Card Dispenser
Page
8/10
8. Maintenance And Cautions
8.1 Maintenance
After using for long some time or dispensing amount of cards, the dispenser
may be weared out, because of every part is running, so we need to do some
maintenance to the machine. The steps as follows:
1
）
Check the parts of the dispenser. If they become loose or abnormal,
tighten them.
2
）
Check the straps of drive wheels. If they become loose, calibrate the
position of the elasticity wheel.
3
）
Use cleaning card or soft cloth with alcohol to clean the dispenser
wheel in the bottom of the hopper and the drive wheel.
4
）
Use soft cloth with alcohol to clean the dirty cards and replace the
distortion cards
5) Check the graduation of knob to see whether they are corresponding.
8.2 Cautions For Safe Use
1
）
Ensure the power is off while repairing the whole machine.
2
）
Notice the cathode and anode of the machine power while power on for
the first time.
3
）
Notice the Specification of JUMP when using for the first time, because
improper JUMP will cause work off or unpredictable status.
4
）
Prohibit to inset or pull out the receptacle of the port when power on.
Otherwise, the circuit of the controller circuit may be spoiled
5) Ensure the dispenser out of smear. The smear will affect the capability
of the dispenser.
6) On the back of dispenser side board, there is a red soft manual “Reset”
keystoke. When error or abnormal situation occurs on spot, then
engineer can press this keystoke for reset. It is not used in general
situation.
7) Reset function: cards cleaning up in stacker and withdraw cards.
8) Reset over time protection: Motor will stop running to protect itself if
pressing the Reset bottom for a long time.
