Installing WebCam Go Plus 1-3
Figure 1-2 shows the buttons and LCD display on the camera.
• To view pictures that you have
taken while using the camera
on-the-go, you must connect
the camera to the computer
and download the pictures
using WebCam Go Control.
• As JPEG compresses an image
according to its details, colours
and compression ratio, the file
size varies according to the
picture taken.
• The counter value decreases
by one every time a picture is
taken. However, if there is
insufficient memory, the
counter will drop to zero
immediately.
Figure 1-2: Buttons and LCD display on WebCam Go Plus.
Multiple-Snapshot mode
In this mode, the camera takes a series
of pictures, with a constant interval
between consecutive takes. By default,
the total number of pictures taken is 10
and the interval is 0.5 seconds.
If the interval is set to zero seconds, a
video is created. You can change this
interval using WebCam Go Control.
Self-timer Multiple-Snapshot mode
In this mode, the camera takes a series of
pictures after a specified length of time,
with a constant interval between
consecutive takes. The default delay time
is eight seconds, the total number of
pictures taken is 10, and the interval is 0.5
seconds.
Single-Snapshot mode
In this mode, the camera captures the
view in one single shot.
Self-timer mode
In this mode, the camera takes a picture
after a specified length of time. The
default delay time is eight seconds.
Image counter
Shows the remaining number of pictures that
can be taken with the camera undocked.
When the counter reaches “000”, you cannot
take any more pictures until you have cleared the
camera’s memory by downloading or removing
the existing pictures.
Audio Record button
Press and release to start recording
your voice or sounds. The displayed
counter shows the remaining time left to
do audio recording.
Press again to stop recording.
Note: Just position the camera near the
sound source. You need not position it
directly at the microphone.
On/Off button
To turn on the camera, press this button.
You can only turn it on when the camera is
disconnected from the system.
To turn off the camera, press and hold for
two seconds.
Note: The camera will turn itself off if it is
left idle for one minute. This length of time
can be changed by using WebCam Go
Control.
Battery-low indicator
Lights up when the battery is running low.
When the battery is low:
i. the idle-timeout is set to 10 seconds;
ii. the Power LED blinks rapidly;
iii. no pictures can be taken.
Mode button
Press to switch to one of the
following four modes of the
camera: single-snapshot mode,
multiple-snapshot mode, self-
timer mode or self-timer
multiple-snapshot mode.
