General Instructions
In order to set up the machine for its initial use and especially
for the insertion of the sticker and film rolls, adult assistance is
required. This operation is necessary when setting up the
machine and whenever you replace the rolls.
«
No adult supervision is required to create the stickers.
Read the instructions carefully before you begin to create
stickers. Use the illustrations to help you.
Follow the instructions, step by step, in order to achieve
the desired results.
DO NOT clean the device with water. Contact with water can
damage the machine.
Refill sticker and film rolls are available for purchase, so you
can use the machine over and over again for many hours of
creative fun.
upper corer
lower
corer
slots
recess
cutting lever
knob
transparent
film
opaque
sticker paper
tool card
2 roll holders
roller
1. Place the sticker-making machine in front of
you, with the cutting lever facing you and
slide the cutting lever all the way to the
right end of the cutting track, so that the
lever is flush against the device. See Figure
1.
2. Turn the device so that the lower cover is on
the right and the upper cover is on the left
(if you are left-handed, turn it in the
opposite direction). See Figure 2.
3. Open both of the device covers. Under the
lower cover is a recess and under the upper
cover are two slots, one on each side.
See Figure 3.
4. Place the sticker roll in the recess so that the
sticker paper is coming off the top of the
roll, from right to left, with the shiny side
up. See Figure 4.
5. Thread the end of the sticker paper under
the two plastic guides and into the slot
between the two black rollers at the other
end of the device. See Figure 5.
6. Turn the green knob on the left side of the
device in a counter clockwise direction until
the end of the paper is held in place
between the rollers. See Figure 6.
7. Insert the 2 film roll holders into the two
ends of the roll of film. See Figure 7.
8. Grasp the roll of film in one hand, by
holding the two holders (one at each end)
and free about 2” (5 cm) of the adhesive
film. Place 0.8” (2 cm) of the end of the
adhesive film on the shorter side of the tool
card, so that the tool card is attached to the
clear roll of film. See Figure 8.
9. Continue holding the roll of film in one
hand and use the other hand to insert the
tool card (the side opposite the end with
the adhesive film attached) into the slot
between the two black rollers. See Figure 9.
10. Turn the green knob on the left side of the
device in a counter clockwise direction until
the end of the tool card is held in place
between the rollers. See Figure 10.
Continue turning the knob in the same
direction, until the tool card is between the
rollers up to the point where the beginning
of the adhesive film is stuck to the tool card.
Please note that the sticker paper will
advance together with the tool card when
you turn the knob.
11. Place the film roll holders in the slots on
either side of the machine until they are
situated at the bottom of the slots. See
Figure 11a. Close both the upper and lower
covers. See Figure 11b.
1
cutting lever
2
4
5
6
7
8
9
10
11
11
33
recess
slot
slot
3+
# 54
77 (EN)
Operating Instructions
TM