Yorktown Play Floor - 19795-200B (04/20)
Copyright 2010, Creative Playthings - Printed in U.S.A.
Page 3
Page 3
STEP FIVE – Stringers & Cleat
A
A
STEP FOUR – Brackets
Hold an Access Bracket against a middle post aligned
with the open hole. Mark the position of the other hole
in the bracket on the adjacent Sandbox Back.
Drill a 3/8" diameter hole through the board at the
mark. Secure the Bracket to the post using a 5/16 x
3" Hex Bolt Assembly. Secure the
Bracket to the Sandbox Back
using one 5/16 x 1-1/2" Hex
Bolt Assembly.
Repeat with the other
Bracket at the other side of
the gym.
Locate one Cleat from the Lexington Play Floor box.
Secure the four Porch Stringers (C) between the Transi-
tion and the Sandbox front using 5/16 x 3" Lag Screws
with flat washers across the front.
Use the included 5/16 x 5-1/2" Lag Screws and Flat
Washers to fasten the Lexington Floor Cleat through
the Transition into the Porch Stringers.
STEP SIX – Deck Boards
Set one Floor Board (B) atop the Transition with the
edge of the Floor Board aligned with the edge of the
Transition.
Evenly space the rest of the Floor Boards between the
first board an the Sandbox End at the front of the tow-
er. Secure each Floor Board using eight #10 x 2" Deck
Screws. Use #10 x 1-5/8" Deck Screws in the places the
screws might encounter the Lag Screws at the end of
the Porch Stingers.
STEP SEVEN – Hole Caps
Gather the Hole Caps removed in step one. Re-insert the Hole
Caps into the accessible counter-bored holes to cover the
hardware.
C
C
B
B
5/16 x 3-1/2"
Lag Screws
5/16 x 5-1/2"
Lag Screws
If the porch play floor is to be installed without the adjacent
tower play floor, use 5/16 x 3-1/2" Lag Screws in place of the
5/16 x 5-1/2" Lag Screws. (These extra 5/16" x 3-1/2" Lag
Screws are not included.)
5/16 x 3-1/2"
Hex Bolt
5/16 x 1-1/2"
Hex Bolt
Lex Floor
Cleat from the
Main Tower
Play Floor
Align
Edge
Sandbox
Back.
