Page 6
©
Copyright 2006, Creative Playthings. Printed in U.S.A.
19718-300 Rev C (05-20)
7 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
STEP 7 – Raise the Swing Beam
Slowly raise the Swing Beam off the ground until the holes
from the Beam Retainer, L-Brace and the third hole from the
top end of the Corner Post line up and the Beam is level.
Position the Legs to support the Beam.
Step 8 – Leg Brace
Align the Leg Brace (C) to the Leg Assemblies. Make sure
the Leg Brace is level.
At the contact point, mark the placement of the holes of the
Leg Brace to the Leg Assemblies. Drill a 1/4" diameter hole
and 1" deep on each mark made. Fasten the Leg Brace to
the Leg Assemblies using two 3/8 x 4" Lag Screws and two
3/8" Flat Washers.
C
STEP 9 – Secure Legs to T-Bracket
Fasten the Leg Assemblies to the T-Bracket Assembly using
two 3/8 x 4" Lag Screws and two 3/8" Flat Washer. (Drill 1/4"
diameter pilot holes in the Leg Assemblies for the Lag Screws).
Tighten the Hex Bolt Assembly that connects to the Angle
Brace.
