Page 7
©
Copyright 2006, Creative Playthings. Printed in U.S.A.
19718-300 Rev C (05-20)
7 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
STEP 10 – Secure the Beam Retainer
Secure the Beam Retainer to the Swing Mount through the top
and bottom holes using two 3/8 x 3-1/2" Hex Bolt Assemblies.
Tighten all fasteners.
In order to assure that the Hex Bolts fully engage with the
Weld Nut, the Hex Bolts used in this step are slightly longer
than necessary. Please use additional Flat Washers if the
end of the Hex Bolt extends more than 1/8" beyond the
Weld Nut.
STEP 11 – Hole Caps
Make sure that all hardware is secure. Install 1" Hole Caps in
the counter-bored holes.
Hex Bolt
3/8 x 3-1/2"
STEP 12 – Stakes
Drive each Stake into the ground next to the Swing Beam
Legs, as shown. Secure the Stakes directly into the base of
the Leg Assemblies using two #10 x 2-1/2" Screws each.
NOTE:
The top of the Stakes must NOT extend beyond the
profile of the leg.
Use Additional
Flat Washers
Use Additional
Flat Washers
