MODEL PS20ROC
19965-200 Rev B (09-20)
© Copyright 2014, Creative Playthings
Page 17
ASSEMBLY INSTRUCTIONS
STEP 22 — Climbing Rocks:
Fasten one Climbing Rock (AN) to each Rock Board using
two 1/4 x 1-1/2" Hex Bolts, 1/4 Lock Washers,
8mm Flat
Washers
and 1/4" Weld Nuts.
1/4 x 1-1/2"
Hex Bolt
1/4" Lock
Washer
8mm Flat
Washer
AN
STEP 23 — Wall Slats:
Fasten three Wall Slats (Y) in place as shown using two #10 x
1-5/8" Screws each to the Platform Right and using two #8 x
1-1/4" Screws each to the Side Arch. Evenly space the Slats
between the Narrow Deck Board and Back Right Post.
The gap between the Slats will be approximately 1-1/2". Use a
level to ensure the Slats are plumb.
Y
#8 x 1-1/4" Screws
in the top holes.
#10 x 1-5/8" Screws
in the bottom holes.
STEP 24 — Climbing Rope:
Push one end of the Climbing Rope (AO) through the hole in
the Top Rope Support. Tie a figure-eight knot at the end of
the rope, inside the gym. Leave at least 3" of rope extending
beyond the knot inside the gym.
From the outside of the gym, tie an overhand knot approxi-
mately every 9" along the length of the rope. Make sure each
knot is tight.
Push the loose end of the rope through the hole in the Rope
Board. Pull the rope taut and tie a figure-eight knot to secure
it.
Set the Rock Uprights into the playground surface to
ensure that the bottom rope connection is as close to
the ground as possible.
IMPORTANT: Check the rope often. At no time should
the bottom end of the rope be untied or the rope loose
enough to form a loop. This presents extreme danger to
children.
AO
Figure Eight
Knot
If the rope is too long,
tie extra knots along the
length of the rope. If too
short, remove knots.
Overhand
Knot
