MODEL PS18EAS
19862-700 Rev A (07-20)
© Copyright 2014, Creative Playthings
Page 9
ASSEMBLY INSTRUCTIONS
STEP 1 — Assemble Posts:
Locate Back Left Post (N), Back Right Post (O), Front Left
Post (P), and Front Right Post (Q).
Secure each post using two 1/4 x 3" Hex Bolt Assemblies
through the three central holes as shown at left. If the tip of
a Hex Bolt protrudes, add a second Flat Washer next to the
first.
N
P
O
Q
1) These holes are
higher on back posts.
3) These holes face
opposite on the left
& right front posts
Note orientation
of holes
2) No holes here
on Back Right Post
Hint: The posts can be difficult to tell apart. There are three
clues at left.
1) The holes for the Platform Ends are higher on the back
Posts.
2) There are no holes for a Lower Wall Support on the Back
Right Post.
3) Look at the holes on the narrow edge of the post to tell the
Left Front Post from the Right Front Post.
STEP 2 — Front of Tower:
Fasten one Sandbox End (E) to the front of the Front Left
Post (P) and Front Right Post (Q) as shown. Use 1/4 x 4"
Hex Bolt Assemblies in the top holes and 1/4" x 2" Lag
Screws with 1/4" Flat Washers in the bottom holes.
Repeat the process with the Platform Front (G) and Front
Arch (J). Align the hole at the center of the Platform Front
closer to the upper end of the tower.
Front of
tower
The posts are shown in the positions
they will be in the final assembly.
The parts required to start assembly are in box 1, subse-
quent parts are in box 2 and box 3.
Hex Bolt Assembly:
Throughout this guide a Hex Bolt Assembly consists of one Hex
Bolt, one Lock Washer, one Flat Washer and one Weld Nut.
1/4 x 4" Hex Bolts in
top holes, 1/4 x 2" Lag
Screws in bottom holes.
P
E
G
J
Q
