© Copyright 2014, Creative Playthings
MODEL PS18EAS
19862-700 Rev A (07-20)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 19 — Short Wall Slats & Entrance Slats:
Fasten three Short Wall Slats (AG) to the Left Wall Support and
Lower Wall Support using four #8 x 1-1/4" Screws each. Even-
ly space the Slats between the front left post and the left Mid
Post. The gap between the Slats will be approximately 1-5/8".
Fasten six Short Wall Slats (AG) to the Left Wall Support and
Lower Wall Support using four #8 x 1-1/4" Screws each. Even-
ly space the Slats between the back left post and the left Mid
Post. The gap between the Slats will be approximately 1-7/8".
Fasten three Short Wall Slats (AG) to the Right Top Support
and Short Wall Support using four #8 x 1-1/4" Screws each.
Evenly space the Slats between the front left post and the left
Mid Post. The gap between the Slats will be approximately
1-5/8".
Fasten the Entrance Slats (AL) to the inside of the Right Wall
Support and Rock Wall Mount using #10 x 1-5/8" Screws. Leave
a gap of 19" between the Entrance Slats.
STEP 20 — Narrow Wall Slats:
Fasten six Narrow Wall Slats (AK) to the Platform Back and
End Support using four #8 x 1-1/4" Screws each. Evenly space
the Slats between the Back Left Post and Back Right Post. The
gap between the Slats will be approximately 2-3/4".
Parts omitted
for clarity
AG
AG
AK
AL
19"
AJ
STEP 21 — Safety Rail:
Hold the Safety Rail (AJ) in place against the left posts, un-
der the Swing Mounts, approximately 23" above the ground.
Fasten the Safety Rail to the posts with two 1/4 x 3-1/2" Lag
Screws and Flat Washers using the pre-drilled pilot holes.
