PINE SKYBOx SPIRAL SLIDE
19694-200 Rev C (07-16)
© Copyright 2005, Creative Playthings, printed in U.S.A.
Page 3
ASSembly inStruCtionS
drill Holes for an end mounted Slide
Use the Mounting Plate (A) to lay out the
mounting hole positions. Align the top edge of
the Mounting Plate (A) with the top edge of
the End Wall Support. The top left hole of the
Mounting Plate (A) should center 9" from the
end of the End Wall Support, as shown. With
a pencil, mark the position of the four holes at
the corners of the Mounting Plate (A). Bore
holes through the End Wall Support and End
Platform Support at the pencil marks, using a
3/8" diameter drill.
Side mounted Spiral Slide (tent roof Gym only)
end mounted Spiral Slide
SteP 2 - drill mounting Holes
End Wall
Support
End Platform
Support
A
9"
Parts omitted
for clarity
drill Short end Wall Support
Hold the Short End Wall Support at the place where it was in-
stalled. Mark the position of the exposed hole of the L-Brace
on the Short End Wall Support. Drill a 3/8" Diameter hole
through the Short End Wall Support at the mark.
Re-fasten the Short End Wall Support to the Post Extensions
as shown in the Skybox manual.
Fasten long Wall Slat
The Long Wall Slat adjacent to the L-Brace will overlap the
L-Brace. Hold the Long Wall Slat in place and mark the po-
sition of the hole in the L-Brace. Drill a 3/8" diameter hole
through the Long Wall Slat at the mark.
Fasten the Long Wall Slat to the Short End Wall Support and
the L-Brace using a 5/6" x 2" Hex Bolt Assembly. Continue
installing the Wall Slats as shown in the Skybox manual.
Omit the screw from the hole that lands on the L-Brace.
(Note: If the L-Brace is on the side without Wall Slats, use
a 5/16 x 1" Hex Bolt Assembly.)
