Page 8
©
Copyright 2005, Creative Playthings. Printed in U.S.A.
19716-400 Rev C (11-20)
9 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
STEP 16 – Stakes
Drive each Stake into the ground next to the Swing Beam
Legs, as shown. Secure the Stakes directly into the base
of the Leg Assemblies using two #10 x 2-1/2" Screws each.
Fasten the last Stake on the inside of the Gym Base Exten-
sion using two #10 x 2-1/2" Screws.
NOTE:
The top of the Stakes must NOT extend beyond the
profile of the leg.
Special Instructions for Mounting the 9 Foot
Swing Beam to a Norfolk Gym with a Wood Roof
The 9 Foot Swing Beam mounts to the inboard side of the
Corner Post on the Norfolk gym with a Wood Roof. To mount
a 9 Foot Swing Beam to a Norfolk with a Tent Roof an adapter
package (P/N 63057-102) must be purchased. Follow the
instructions included with the package.
Please note: the Gym Brace and Gym Brace Extension are
not required on the Norfolk Gym.
Drill Holes
Using the top hole for the End Support as a guide, drill two
7/16" diameter holes through the center line of the Corner
Post. One hole should be 8" above the guide hole and the
other should be 12-1/8" above the guide hole. The L-Brace
and Beam Retainer can be used as templates.
Install Beam
Remove the Hole Cap and Bolt Assembly from the End Sup-
port hole that was used as a guide.
Go to page 3 of these instructions and follow the instructions
for installation of the 9 Foot Swing Beam. When fastening
the L-Brace and Beam Retainer to the Corner Post, reverse
the original Hex Bolt Assembly from the End Support. Insert
the Weld Nut into the counter-bored hole in the End Support.
Insert the Bolt through the Lock Washer, Beam Retainer.
L-Brace and Corner Post. It is important that the Hex Bolt
penetrates the Weld Nut by at least 1/2", if it does not a longer
bolt (4-1/2") must be used (may not be included).
4-1/8"
8"
Mount Beam to the
inboard side of the
Corner Post
Use the top hole for
the End Support as
a guide
Reverse the Hex
Bolt Assembly. A
4-1/2" Bolt may be
required
IMPORTANT: When installing
a Swing Beam to a Norfolk or
Manchester Gym, do not install
the two swing hangers closest to
the gym. The area must be kept
clear for tire swing clearance.
