Page 5
©
Copyright 2005, Creative Playthings. Printed in U.S.A.
19716-400 Rev C (11-20)
9 Ft. Swing Beam
ASSEMBLY INSTRUCTIONS
Hex Bolt
3/8 x 7-1/2"
Hex Bolt
3/8 x 4"
I
A
J
STEP 7 – Install the Swing Beam
NOTE:
This step requires at least two people to complete.
Fasten the Beam Retainer (I), the Swing Beam Assembly
(A) and L-Brace (J) to the second hole on the Corner Post
using one 3/8 x 7-1/2" Hex Bolt Assembly, as shown. Secure
the L-Brace to the Swing Beam using one 3/8 x 4" Hex Bolt
Assembly (The Weld Nut should be on the front of the Swing
Beam), as shown.
Note: Use two 3/8 Flat Washers under the Lock Washer on
the 7-1/2" bolt, to prevent the threads from protruding beyond
the Weld Nut.
STEP 8 – Raise Swing Beam
Slowly raise the Swing Beam off the ground until
the holes from the Beam Retainer, L-Brace and the
third hole from the top end of the Corner Post line
up and the Beam is level.
Position the legs to support the Beam.
Step 9 – Leg Brace
Align the Leg Brace (F) to the Leg Assemblies. Make sure
the Leg Brace is level.
At the contact point, mark the placement of the holes of the
Leg Brace to the Leg Assemblies. Drill a 1/4" diameter hole
and 1" deep on each mark made. Fasten the Leg Brace to
the Leg Assemblies using two 3/8 x 4" Lag Screws and two
3/8" Flat Washers.
F
