Creative Conners CM Varistar Smart Chain Hoist, Справочное руководство

Страница: 23 / 31

Smart Chain Hoist Reference Manual
Published 4-14-20
334
RS-485 communication parity
check selection
RS-485 Communication 0 0 0
338
Communication operation
command source
RS-485 Communication 0 0 0
339
Communication speed
command source
RS-485 Communication 0 0 0
340
Communication startup mode
selection
RS-485 Communication 0 0 0
359 Encoder rotation direction CCW encoder rotation is forward 0 0 0
368 Feedback gain
Response of the feedback will
become slow when the
acceleration/deceleration time is
long. In such case, increase the
setting value
1 1 1
369 Number of encoder pulses PPR for Vector Control 1024 1024 1024
374 Overspeed detection level
Inverter shuts down if motor
speed is greater than indicated
value. (Hz)
9999 9999 121
376
Encoder signal loss detection
enable/disable selection
Inverter shuts down if the
encoder stops working or the
encoder signal is lost.
1 1 1
414
PLC function operation
selection
enable PLC to run brake
switching logic, must be turned
off to manually auto-tune motor.
A800='2' A700='1'
2 2 1
549 Protocol selection MODBUS RTU protocol 1 1 1
550
NET mode operation command
source selection
The RS-485 terminals are the
command source when in the
NET operation mode
1 1 1
551
PU mode operation command
source selection
The RS-485 terminals are the
command
source when in the PU operation
mode.
9999 9999 9999
800 Control method selection
0=Vector control, speed control,
10=Sensorless Vector control,
20=Volts/Frequency control
0 0 0
802 Pre-excitation selection servo lock 1 1 1
Page 19