Create WIND FOLD, Руководство пользователя

Страница: 22 / 24

22 ENGLISH
BLADE BALANCING KIT
Q
Your ceiling fan may have swinging problems when operating due to irregularities in the
blades or brackets. In addition, incorrect mounting of the system or twisted bearings could
cause additional problems. The following procedure is recommended to remedy these prob-
lems:
1. Make sure the blades are securely screwed into their brackets.
2. Make sure all the blades are securely fastened to the center swivel housing and check the
pitch of the blade holders, they should all be the same.
3. Standing under the fan and looking up, check that none of the blade supports are bent so
that none of the blades are misplaced. You can correct the position of the blade holders by
gently bending them to the correct position.
4. You can check the height of the blades with a ruler. Place the straightedge against the
ceiling vertically level with the outside of the blade tip. Check the distance from the blade
tip to the ceiling, rotate the blades carefully by hand and check the rest. If they are not
aligned, you can carefully bend the bracket up or down a bit to align with each other.
If the balance problem is not solved even by following the steps above, you must perform a
dynamic balance using the kit provided. Follow this procedure:
1. Turn on the fan and set the speed at which the most sway is generated (normally occurs
at the highest speed).
2. Turn off the fan. Select a blade and place the balance clip midway between the bracket
and the tip, on the back edge of the blade.
3. Turn on the fan. Wait to see if the rocking has improved or worsened. Turn off the fan again
and place the clip on another blade to recheck. Repeat this process with all the blades and
see which one has improved the most.
4. Place the clip on the blade that has improved the most. Move it in or out of the blade and
start the fan to find the best position where the clip offers the best balance.
5. Then remove the clip and install a balance weight on top of the blade on the center line
near the point where the clip was placed. Use a knife or blade if necessary to separate the
weights.
Watch out
: Stand at a safe distance from the blades. If the clip has not been properly se-
cured, for whatever reason, you could be injured.
BALANCING KIT