Creality AL-BMG, Инструкция по сборке

Страница: 3 / 25

6. Please make sure that after tightening the heat breaker and nozzle into the AL-BMG-AC extruder
body the heat block position should looks like shown in the picture down below.
7. Install the thermistor and heater cartridge to the heat block as shown in the picture down below.
In this step you have to decide to using which kind of thermistor. It depends on if you want or able to
flash the firmware of your board. There are two type of thermistor in this kit ： 104gt-2 is the yellow
shrink tube one and the black shrink tube is the NTC100K B3950 which commonly used by most cheap
Chinese machines. If you unable to flash the firmware of your machine you may need to install the
NTC100KB3950 thermistor or if your stock thermistor is cartridge style you can use the stock one
instead. If you can flash your board to latest Marlin you can use the 104GT-2 thermistor and choose
“5” Temperature sensor in the Marlin firmware for more accurate temperature reading.