3
A
SSEMBLY CONTINUED
...
Next, install the plastic battery bumpers [7] as shown. You will use the two 4-40 x 1/4” flat
head screws that were removed from the hex standoffs for the center top deck. The inner
plastic pins on the battery bumpers will sit into a hole toward the center of the chassis.
The outer plastic pin will key into a notch on the outside of the chassis, but will not be in a
complete closed hole.
Install the plastic antenna / shock mount [8] in the holes shown using the two included 4-
40 x 3/8” flat head screws [9]. Thread the red 4-40 ball stud [10] into the rear hole of the
antenna mount, and insert the antenna into the front hole of the mount. Use the included
4-40 x 1/8” set screw [11] to lock the antenna into the mount.
7
9
8
10
11
C
OMPLETING
A
SSEMBLY
Last, re-install your rear top plate and damper tubes as shown
to the left, and then re-intall your center shock.
REMEMBER to squeeze the ball cup of the center shock over
the rear top plate ball with pliers and not press down on the
shock with your hand. For the front ball on the antenna mount,
you will need to press straight down on the
with your
hand or a wrench handle,
ball cup
do not press on the shock body.
Содержание Carpet Knife Xti
Страница 4: ......
