10
Power/Control Cable-
Insert female end of cable plug
into housing bore aligning alignment mark with hole
in terminal block see Figures 4 & 5. Tighten bolts on
compression flange until flush with motor housing.
Pump Power - Large Pin
Level Control - Small Pin
Level control cord has molded fitting at both ends of the
cord. Install one end to the Pump and the other end to
the Level Control.
FIGURE 4
FIGURE 5 - Automatic Pumps
Pump & Level Control Wiring
(Pump model may
appear different
than that shown)
Содержание BARNES PRESSURE SYSTEMS omni GRIND plus ULTRA GRIND OGP2022AUE Series
Страница 12: ...12 Typical Wiring Diagram Generic ...
Страница 15: ...15 FIGURE 8 2000 SERIES STATION WIRING WIRING FOR UNITS NOT SUPPLIED WITH FACTORY WIRED EQD ...
Страница 16: ...16 FIGURE 9 PARTS LIST OGP2022AUE ...
Страница 20: ...Notes ...