Crane Barnes 10 ICU-1, Инструкция по установке и эксплуатации

Страница: 4 / 12

4
SUCTION/DISCHARGE . 2” x 2” NPT, Female
LIQUID TEMP ................ 160°F (71°C) Continuous
INTERMEDIATE ............. Cast Iron ASTM A-48, Class 30
VOLUTE ......................... Cast Iron ASTM A-48, Class 30
Removable
BODY ............................. Cast Iron ASTM A-48, Class 30
PEDESTAL ..................... Cast Iron ASTM A-48, Class 30
IMPELLER
Design
........... Semi-Open
Material ........ Cast Iron ASTM A-48, Class 30
Dynamically Balanced, ISO G6.3
SHAFT ............................ Stainless Steel
SHAFT SLEEVE ............ Stainless Steel
SQUARE RINGS ............ Buna-N
HARDWARE .................. 300 Series Stainless Steel
PAINT ............................. Air dry enamel
SEAL
Design
.......... Single Mechanical with Lip Seal
Lubrication
.... Grease
Material
........ Rotating Faces - Carbon
Stationary Faces - Ceramic
Elastomer - Buna-N
Hardware - 300 series stainless steel
BEARING - PUMP END
Design
.......... Single Row, Ball
Lubrication
.... Grease
Load ............. Radial
BEARING - DRIVE END
Design
.......... Single Row, Ball
Lubrication
.... Grease
Load
............. Radial
CHECK VALVE:
Material ........ Valve Flap - Neoprene
Weight - Cast Iron ASTM A-48, Class 30
OPTIONAL EQUIPMENT: Seal Material, Flex Coupled Assy.
with Base & OSHA Guard; Right Hand V-Belt Drive Assy.,
Left Hand V-Belt Drive Assy. and In-Line Vertical V-Belt Drive
Assy. with Base, Motor Adjusting Base & OSHA Guard.
SECTION: A - PUMP SPECIFICATIONS
inches
(mm)
IMPORTANT!
1.) DO NOT USE FOR PUMPING FLUIDS WITH A FLASH POINT OF LESS THAN 100°F.
2.) MAKE CERTAIN THAT PUMP AND/OR MOTOR ASSEMBLY AND CONTROLS HAVE THE APPROPRIATE RATINGS FOR THE GIVEN
APPLICATION AREA CLASSIFICATION (ie DIVISION I, AGENCY LISTING ETC.)