Sweeper H
Original Operation Manual English
-7
7.
Release and tilt back steering
bracket (for transport and storage)
1.
Release wing bolts. The wing bolt is located on the right and left above the drive wheel
2.
Hold Bowden cable at the right and left of the motor block
3.
Carefully turn steering bracket to motor cover (observe Bowden cables!)
4.
Position swivel bracket as shown in figure
5.
Tighten wing bolts.
8.
Support wheel adjustment
Lever pointing right
Support wheel can be moved freely
Travel is possible in all directions
Lever pointing left
Support wheel is fixed
Direction of travel is straight, helpful with inclined
brush setting
Changing the brush speed for varying
operations
Low speed (for sweeping dirt)
High speed (for clearing snow).
This setting is factory assembled.
For the various brush speeds, the V-belt runner must be routed over the V-belt pulley
shown in the illustration.
1.
Switch off the machine (turn throttle to
O
)
2.
Completely unscrew the crank
3.
Remove the 4 fastening screws at the side
4.
Remove the cover
5.
Reposition the V-belt on the other V-belt pulley
6.
The V-belt must be routed as shown in the illustration
7.
Secure the cover using the 4 screws.
8.
Screw in the crank.
3.4
Working position and areas of risk
Working position:
Behind the machine on the handles
Areas of risk:
•
Catchment area of sweeping brushes
•
Ejection area of sweeping brushes
3.5
Accessories and spare parts
Original parts
Only original spare parts and original accessories may be used.
