FLIP TARP
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com - Manual no. MFT002-EN-ED07 – date 02/05/2017
Page 12
1
2
3
ASSEMBLY PROCEDURE
Preparing the container
1.
Level and/or repair any uneven areas and/or crushed or broken areas on the upper edges of the sides
(ATTENTION: SHARP IMPERFECTIONS MAY CUT THE TARPAULIN!)
2. Any sharp angle the tarpaulin might come in contact with by resting on it must be rounded (see detail A), as
it might block and/or damage the tarpaulin
Positioning and attaching the front tarpaulin housing
Position and secure the tarpaulin housing on the front portion of the container.
It is possible to position the front tarpaulin housing either on the overhanging portion of the cab-shield, or behind
the front wall of container
Fig. 3
After positioning the two side covers and the tube used to roll the tarpaulin in the desired position and carefully
make sure it is PARALLEL to the front profile of the container. It can be secured to the cab-shield with the M8
screws supplied in the assembly kit.
Fig. 4
the tarpaulin housing can be mounted at a later stage by attaching it to the two side covers of the housing itself
with special M8 convex screws supplied for this purpose.
