CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
57
14.
ON THE FRONT PART
of one side of the container or on its front wall (if there isn't one already) secure, by
welding or riveting, a BRACKET WITH TWO HOOKS (ROPE-WINDER BRACKET) supplied so you can wind
the tail traction ropes when the tarpaulin is fully retracted at the front of the container.
15.
ON THE REAR PART,
on the rear loading door of the container (if there isn't one already) secure, by welding
or riveting, the other ROPE-WINDER BRACKET.
ADDITIONAL ROPE TO FACILITATE LIFTING OF THE ROLLED TARPAULIN.
To increase the space
available under the last bow
to unload the transported material,
a simple but very efficient innovation was added to
the initial tail with spring model,
which allows you
to further lift the sheet
when it is completely rolled up.
The innovation consists in applying
an additional rope in the lower part of the
peak of the last bow (the one to which the
tail with spring is attached).
The rope, anchored to the bow underneath the
sheet and kept taut while the tail is being
rolled up, is of great help in supporting
the tarpaulin roll and, above all,
once the tail is completely rolled up,
bringing both ropes toward the front of the container,
it keeps the roll in a higher and, therefore, less cumbersome position under the bow, greatly benefiting the container
covering and uncovering operations.
J
= tail with return spring
A
= main tail return rope
B
= secondary support and roll-holding rope
C
= additional rope anchoring clevis
R
= clevis fastening rivets
