Craig CHT940DO, Руководство пользователя

Страница: 8 / 16

BATTERY INSTALLATION ( REMOTE CONTROL)
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
8
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment, a reserved battery may cause damage to the device.
3. Do not mix different types of batteries together ( e.g: Alkaline and Carbon-zinc ) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or the device is not to be used for a long
period of time, remove the batteries to prevent damage or injury from possible leakage.
rupture. ( Follow battery manufacturer’s instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Clean the battery contacts and also those of the device prior to battery installation.
8. The remote control supplied with a coin/button cell battery. If the coin button cell battery
is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used battery away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body,
seek immediate medical attention.
5. Do not try to recharge the battery not intended to be recharged; it can overheat and
Fig.1 Fig.2
Fig.3
2. Replace the battery by a new CR2025 button cell
with the polarity “+” facing up as the figure below.
3. Close the battery tray.
NOTES:
fluorescent lamp or any other strong light
shines on the REMOTE SENSOR of the unit,
the remote operation may be unstable.
°
30
°
30
Approx. 16 feet
Remote Sensor
---First time using:
Remove and discard the insulation film as the figure on right.
---If the battery is consumed, replace it as below:
below and the markings on the rear of the remote control.
●
When there is an obstacle between the unit
and the transmitter may not operate.
●
When direct sunlight, an incandescent lamp,
1. Push and slide out the battery tray as the figure