Craftsman CMXEVBE176560, Инструкция по эксплуатации

Страница: 12 / 60

Should it become necessary to pick the Vac up to move
it, use the Carry Handle and/or the Dust Drum Handles.
NOTE:
Do not move Vac by the Powerhead Latches.
To maneuver the Vac, use the Metal Handle and/or the
Carry Handle.
Moving the Wet/Dry Vac (Fig. T)
Fig. T
Your Vac features a Blowing Port. It can blow sawdust
and other debris. Follow the steps below to use your Vac
as a Blower.
1. Locate Blowing Port of your Vac, located at the back of
the Powerhead Assembly.
2. Insert the Locking End of the Hose Assembly into the
Vac Blowing Port. The Hose should snap into place.
To remove the Hose from the Vac, press the Release
Button in the Hose Assembly and pull the Hose out of
the Vac Inlet Port.
3. (Optional) Attach Extension Wand to opposite end of
Hose, then place the Car Nozzle on the Wand.
4. Turn Vac on and you are ready to use your Vac as a
Blower.
Blowing Feature (Fig. V)
Fig. V
12
Fig. U
Muffler / Diffuser (Fig. U)
Insert the Locking End of the Muffler / Diffuser into the
Blowing Port of the Vac. The Muffler / Diffuser should snap
into place.
The Muffler / Diffuser suppresses motor noise and diffuses
the exhaust air and can be used while vacuuming indoors
or outdoors.
Muffler / Diffuser
Muffler/Diffuser
Release Button
(Locking End)
Vac Blowing Port
WARNING:
Always wear safety eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before using as a blower.
!
WARNING:
To reduce the risk of injury to bystanders, keep them
clear of blowing debris.
!
CAUTION:
Wear a dust mask if blowing creates dust which might
be inhaled.
!
CAUTION:
To reduce the risk of hearing damage, wear ear
protectors when using the Vac / Blower for an extended
time or in a noisy area.
!
Metal Handle
Carry
Handle
Dust Drum
Handles (2)
Powerhead
Latches (2)
Swivel End
Of Hose
Extension
Wand (Optional)
Car Nozzle
(Optional)
Locking
Hose End
Blowing
Port