Craftsman CMXEBAR600, Инструкция по эксплуатации

Страница: 13 / 24

13
English
Support bearing (Fig. Q)
1. Loosen the support bearing hex screw 44 on the right
side of the band saw with the hex wrench.
2. Move the support bearing shaft 48 in or out until the
support bearing
49
is 1/64 in. (0.4 mm) behind the saw
blade.
3. Tighten the support bearing hex screw 44 .
4. The back edge of the blade 24 should be positioned
1/16 in. (1.6 mm) to 1/8 in. (3.2 mm) from the surface of
the support bearing
49 .
Drive belt tension (Fig. R)
1. Disconnect the machine from the power source.
2. Loosen the hex socket screw
50 on the motor with a
6 mm wrench. Do not remove the hex socket screw
50
.
3. Push the motor down to add tension to belt. Move the
motor up to loose tension to belt.
4. The belt is properly tensioned when moderate finger
pressure on the belt between the two pulleys causes a
1/2 in. deflection.
5. Tighten the hex socket screw 50 that secures motor.
Lower Blade Guides And Support Bearing
(FIG. O, P, Q)
WARNING: To avoid injury, turn the switch OFF and
disconnect the saw from the power source before
making any adjustments.
NEVER
make adjustments
with the machine running.
NOTE: Make sure the blade is tensioned and tracking properly.
The lower blade guides and support bearings should always be
adjusted after the blade is tensioned, the tracking is adjusted,
and the upper blade guides and upper support bearings are
properly adjusted.
Blade guides (Fig. O, P)
1. Loosen two front hex socket screws 42 with a hex
wrench. (Fig. O)
2. Move the guide pins 43 as close to the sides of the
blade 24 as possible without pinching it.
3. Using the feeler gauge, measure the spaces
between the guide pins and the blade. Adjust to
0.002 in. (0.05 mm).
4. Tighten two front hex socket screws 42 .
5. Loosen two lock screws
47
, move the lower blade
guide 9 in or out until the guide pins ( 43 -Fig. O) are
just behind the saw teeth. Tighten two lock screws 47 .
(Fig. P)
Fig. O
Fig. P
9
47
Fig. Q
Fig. R
tension
loose
50
49 48
44
24
42
43
24
43
42