Craftsman CMXEBAR600, Инструкция по эксплуатации

Страница: 18 / 24

English
18
PROBlEM CAUsE CORRECTiOn
Noisy operation. 1. Incorrect belt tension.
2. Loose motor pulley.
3. Loose pulley cover.
1. Adjust tension. See ASSEMBLY AND ADJUSTMENTS section - "DRIVE BELT
TENSION."
2. Readjust and tighten motor pulley set screw.
3. Readjust and tighten pulley cover mounting screws.
Motor will not start. 1. Not plugged into power outlet.
2. Switch and key not in ON position.
3. Motor cord cut or abraded.
4. Plug on cord is faulty.
5. Fuse on circuit breaks open.
6. Faulty motor. 1. Plug it into the power outlet.
2. Insert key and turn the switch ON.
3. Re-set; may be too many machines on line.
4. Contact Service Center or Authorized Service Station.
5. Contact Service Center or Authorized Service Station.
6. Contact Service Center or Authorized Service Station.
Motor will not start and fuse
or circuit breaker opens. 1. Too many electrical machines.
2. Incorrect fuse.
3. Wheels do not rotate.
4. Undersized extension cord.
5. Short circuit.
1. Turn off other machines and try again.
2. Try time delay fuse, or go to circuit with higher rated fuse or circuit
breaker.
3. Unplug and turn wheels by hand, move obstruction.
4. Use correct size extension cord, see page 7.
5. Contact Service Center or Authorized Service Station.
Motor fails to develop full
power. 1. Low line voltage.
2. Faulty motor or capacitor. 1. Check power line for proper voltage.
2. Contact Service Center or Authorized Service Station.
Motor overheats. 1. Overload on motor.
2. Poor ventilation of motor.
3. Capacitor failure. 1. Reduce load to motor, feed work slower into blade.
2. Unplug and clean out around motor. Provide better air circulation.
3. Contact Service Center or Authorized Service Station.
Motor stalls or slows. 1. Motor overload.
2. Low line voltage.
3. Loose wire connections.
4. Faulty motor. 1. Reduce load to motor, feed work slower into blade.
2. Check power line for proper voltage.
3. Contact Service Center or Authorized Service Station.
4. Contact Service Center or Authorized Service Station.
Frequent fuse or circuit
breaker failure. 1. Motor overload.
2. Overload of electrical circuit.
3. Incorrect fuse or circuit breaker. 1. Reduce load to motor, feed work slower into blade.
2. Too many electrical appliances on same circuit.
3. Have electrician upgrade service to outlet.
MOTOR