Craftsman C459-527860, Руководство оператора

Страница: 9 / 56

ASSEMBLY
CHuTE CLEAN-OuT TOOL
WARNING: Never use your hands to clear
a clogged chute assembly. Shut off engine
and remain behind handles until all moving
parts have stopped before unclogging.
The clean-out tool is mounted to the rear of the auger housing and is
designed to clear a clogged chute. Refer to page 11
for instructions on
how to properly use it.
NOTE:
This item is fastened with a cable tie to the rear of the auger
housing at the factory. Cut the cable tie before operating the snow
thrower.
LAMP WIRINg HARNESS
The cable ties are loosely attaching the lamp wiring harness to the
lower handle. Pull the slack portion of the wiring harness through the
cable ties to prevent interference with the recoil starter handle and pull
the cable ties tight to secure. Trim excess from the ends of the cable
ties. See Figure 9.
NOTE: Be careful not to bend of kiNk the wire.
DRIFT CuTTERS
Drift cutters should be used when operating the snow thrower in
heavy drift conditions.
Drift cutters are assembled to the auger housing inverted. See
Figure 10. Remove the carriage bolts by unthreading the hex nuts
which secure them, and reinstall the drift cutters in their proper
position before operating the snow thrower. See Figure 11. •
•
Figure 9
Figure 10
Figure 11
Chute Clean-out Tool
Figure 8