Craftsman C459-527860, Руководство оператора

Страница: 15 / 56

1
ADJUSTMENTS
SHIFT ROD ADjuSTMENT
Remove the hairpin clip and flat washer from the shift handle
under the handle panel. See Figure 16.
Place shift lever in sixth (6) position or fastest forward speed.
Push shift arm assembly down as far as it will go.
Rotate the ferrule up or down on the shift rod as necessary until
the ferrule lines up with the upper hole in the shift lever. See
Figure 16.
Insert ferrule from the left side of the snow thrower into the upper
hole.
Reinstall the hairpin clip and the washer.
Make certain to check for correct adjustment of the shift rod as
instructed under “Drive Control and Shift Lever” on page 14,
before operating the snow thrower. •
•
•
•
•
•
•
Upper Shift Rod
Hairpin Clip
Lower Shift Rod
Shift Arm
Shift Rod
Connector
Shift Lever
Hairpin Clip
Flat
Washer
Ferrule
Figure 16
Figure 17
Figure 18
SkID SHOE
The space between the skid shoes and the ground can be adjusted.
• For close snow removal on a smooth surface, raise skid shoes
higher on the auger housing.
• Use a middle or lower position when the area to be cleared is
uneven, such as a gravel driveway.
To adjust the skid shoes:
1. Loosen the four hex nuts (two on each side) and carriage bolts.
Move skid shoes to desired position. See Figure 17.
2. Make certain the entire bottom surface of skid shoe is against the
ground to avoid uneven wear on the skid shoes.
3. Retighten nuts and bolts securely.
CHuTE bRACkET ADjuSTMENT
If the spiral at the bottom of the chute directional control is not fully
engaging with the chute assembly, the chute bracket can be adjusted.
To do so:
1. Loosen the two nuts which secure the chute bracket and reposition
it slightly. See Figure 18.
2. Retightening the nuts.