8 - ENG
D23377
Assemble Wheels
It will be necessary to brace
or support one side of the
outfit when installing the wheels because the
compressor will have a tendency to tip.
1.
Attach wheels with shoulder bolts and nuts as
shown.
NOTE:
Place the bolts in the bottom hole
of the wheel bracket on units 20-29 gallons and in
the top hole on units 30 gallons and up.
2.
Tighten securely.
NOTE
: The outfit will sit level if
the wheels are properly installed.
The wheels and handle
do not provide adequate
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.
Assemble Rubber Strip
1.
Clean and dry underside of air tank leg opposite
wheels.
2.
Remove the protective paper strip from the adhe-
sive backed rubber foot strip.
3.
Attach the rubber foot strip to the bottom of leg.
Press firmly into place.
Rubber Strip
Screw
Nut
Wheel
Shoulder Bolt
Unpacking
1.
Remove unit from carton and discard all packag-
ing.
NOTE:
Save all parts bags.
Assemble Handle
1.
Insert the handle inside the compressor saddle
and line up the two bolt holes on each side.
2.
Install the four screws, two on each side.
3.
Tighten securely.
Handle
