Not for
Reproduction
8
5. Place billboard (
A
) over holes (
B
) on handle
(viewing from front of unit). Push the small tree
clips (
C
) into the holes until they sit flat against the
billboard.
6. Insert spray gun holder wireform (
D
) through hole
on handle and attach a plastic knob (
E
). Tighten by
hand.
Project Pro® Perfect Mix™ Siphon
1. Attach the tube end of the blue PerfectMix siphon
(
F
) to the barbed tube fitting (
G
) on the pump.
2. Place Perfect Mix bottle (
H
) (not included) in
spaces of accessory tray.
3. Remove cap from bottle and insert Perfect Mix
siphon (
F
). Screw siphon unit to top of bottle.
Add Engine Oil
1. Place pressure washer on a flat, level surface.
2. Clean area around oil fill and remove yellow oil fill
cap/dipstick.
3. Hold neck of supplied oil pouch and remove cap.
4. Slowly pour contents of oil pouch into oil fill
opening. Checking oil level frequently, fill to FULL
mark (top hole) on dipstick.
NOTICE
Pause to permit oil to settle. Wipe dipstick
clean each time oil level is checked. DO NOT overfill.
NOTICE
Improper treatment of pressure washer
could damage it and shorten its life.
• DO NOT attempt to crank or start the engine before it has
been properly serviced with the recommended oil. This
could result in an engine failure.
5. Replace oil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON). For
high altitude use, see
High Altitude
.
• Gasoline with up to 10% ethanol (gasohol) is
acceptable.
NOTICE
Use of unapproved fuels could damage
pressure washer and voids warranty.
• DO NOT use unapproved gasoline such as E15 and E85.
• DO NOT mix oil in gasoline or modify engine to run on
alternate fuels.
E
D
Full
Add
WARNING
Fuel and its vapors are extremely
flammable and explosive which could
cause burns, fire or explosion
resulting in death or serious injury.
WHEN ADDING FUEL
• Turn pressure washer engine OFF and let it cool at least
2 minutes before removing fuel cap. Loosen cap slowly to
relieve pressure in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
• Check fuel lines, tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
• DO NOT light a cigarette or smoke.
A
B
C
H
F
F
G
Содержание 580.754980
