6
IMPORTANT:
Table is coated with a protectant. To ensure
proper fit and operation, remove coating. Coating is easily
removed with mild solvents, such as mineral spirits, and a soft
cloth. Avoid getting solution on paint or any of the rubber or
plastic parts. Solvents may deteriorate these finishes. Use
soap and water on paint, plastic or rubber components. After
cleaning, cover all exposed surfaces with a light coating of oil.
Paste wax is recommended for table top.
WARNING:
Never use highly volatile solvents. Non flamma-
ble solvents are recommended to avoid possible fire hazard.
ASSEMBLY
Refer to Figures 3-34.
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Be certain all parts are clean and free of shipping preserva-
tive. Also, completely remove all parts of packing. Saw cabinet
should be directly on the floor.
SAW INSTALLATION
Positioning the saw on a level surface will improve stability
and accuracy and prevent warpage and failure of cast
components and welds.
WARNING:
Make certain that the saw is disconnected from
the power source.
INSTALL HANDWHEELS
Refer to Figure 3.
• Remove saw cabinet and place upside down on cardboard
box or cardboard on floor.
• Place one of the handwheels onto the blade raise/lower
shaft located on the front of the cabinet. Align the groove
in the back of the handwheel with the pin.
• Thread the washer and locking knob onto the threaded end
of the shaft.
• Repeat the steps above to assemble the remaining hand-
wheel and locking knob onto the blade tilt shaft located on
the side of the cabinet.
REMOVE PACKING MATERIAL
Refer to Figure 4.
• Use the blade tilt handwheel to tilt the motor completely to
45°.
• Remove the packing material from behind the motor.
• Return motor to the 0° position.
ASSEMBLE MOBILE BASE PANELS
Refer to Figures 5 and 6, pages 6 and 7.
Tools Required: 4mm Hex Wrench
Hardware Required: Twenty-four M6 x 12 socket pan head
bolts (Hardware bag #4).
• Attach the front panel between two corner supports using
six M6 x 12 socket pan head screws.
NOTE:
Place the panel edges INSIDE the corner support
surfaces.
NOTE:
Front panel and rear panel are both stamped ‘A’.
Front panel has warning label.
• Repeat above step for the rear panel.
• Turn all panels upside down to perform base assembly.
• Attach one corner of left panel (stamped ‘B’) to front panel
A.
• Attach the other corner of left panel B to rear panel A.
• Repeat above two steps for attachment of right panel
(stamped ‘C’).
Figure 3
Blade Raise Handwheel
Blade Tilt
Handwheel
Figure 4
Remove this
packing material
Figure 5
Letter Stamp On Top Edge
