Below is completed base assembly.
ASSEMBLE CASTER SETS
Refer to Figures 7-11.
Tools Required: Two
1
⁄
2
″
Open End Wrenches
• Refer to Figure 7; remove casters (4) and supports (2)
from carton.
• Loosen and remove the bolt and hex nut from the bracket
(see Figure 8)
• Rotate foot pedal bar so that kick plate cam is inside
bracket (see Figure 9).
• The kick plate cam must be underneath the caster to func-
tion properly (see Figure 10).
• Refer to Figures 10 and 11; place caster onto the bracket
and secure in position with bolt and hex nut.
• Repeat above steps for the second caster set.
ATTACH CASTER SETS TO BASE
Refer to Figure 12.
Tools Required: 5mm Hex Wrench
Hardware Required: Eight M8 x 16 socket pan head screws
(Hardware bag #4).
• Attach one caster set to the two front corner supports
using four M8 x 16 socket pan head screws.
• Attach the remaining caster set to the two rear corner
supports.
7
Kick Plate Cam
Foot Pedal Bar
Bracket
Figure 7
Figure 8
Figure 9 - Kick Plate Cams Inside the Brackets
Figure 10
Figure 11
Figure 6
C
A
B
A
Figure 12
