12
―
English
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Lines will not feed when
used as per instructions.
1. Lines have become stuck
together due to heat or
storage time.
1. Unplug trimmer. Open spool cover. Remove
spool. Unwind line and then rewind onto spool.
2. Not enough line present in
spool.
2. Unplug trimmer. Open spool cover. Remove spool
and replace with new line or new spool assembly as
per instructions in this manual.
3. Lines are tangled on spool.
3. Unplug trimmer. Open spool cover. Remove
spool. Unwind and remove tangled line. Rewind line
as per instructions in this manual.
Grass wraps around
drive shaft housing and
line head.
1. Cutting tall grass at ground
level.
1. Cut tall grass from the top down to prevent
wrapping.
Motor fails to start
when switch trigger is
depressed.
1. Power cord is not plugged
in or connection is loose.
1. Plug in the power cord.
2. Household circuit breaker
is tripped.
2. Check circuit breaker.
3. Extension cord may be
faulty.
3. Try another extension cord or connect into
another wall receptacle socket on a different circuit.
If your line trimmer does not seem to operate properly,
fi
rst consult the Troubleshooting Table below.
If the solution to your trimmer problem is not found in
the Troubleshooting information, take the trimmer to
a quali
fi
ed service dealer for inspection and possible
repair.
WARNING!
Before proceeding, switch off
and unplug.
