Craftsman 125.04267621-3 evolv, Руководство оператора

Страница: 6 / 31

Assembly (continued)
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection tank.
(Fig. 3)
4. Remove the contents from inside the
collection tank; make sure you have all
contents as listed on page 5. (Fig. 4)
5. Insert the casters into the socket on to
bottom of the collection tank and apply
pressure until castors snap into place.
(Fig. 5)
6. Insert the handle into the slots located
on the top of the power head and
secure it with the screws provided. Do
not over tighten the screws. (Fig. 6)
7. Place the power head back on the
collection tank, aligning the top section
with the latches, and snap into place.
(Fig. 7)
6
WARNING: Do not plug in power
cord to power outlet, make sure plug
is disconnected before assembling
the Wet/Dry Vac.
!
Polarized Plug
To reduce the risk of electrical shock,
this appliance has a polarized plug (one
with the blade wider than the other).
This plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
Double insulation eliminates the need
for the three wire grounded power cord
and grounded power supply system.
A Philips head screw driver is required.
8. Insert the locking end of the hose into
the port on the collection tank and turn
to lock in to place. (Fig. 8)
9. Choose the desired accessories and
insert onto the end of the hose. (Fig. 9)
4
2
2
1
5
8
9
7
3
6
1