9
Attaching The Mitre Saw Mounts
1. Depress the mounting bar handles and hook the
opposite end of the mount onto the frame of the
stand.
2. Lower the handles onto the frame and release
them to lock the mounting bar into place.
3. Repeat the same procedure with the other mounting bar.
Attaching A Mitre Saw
1. Adjust the mounting bars to roughly the width of
the mitre saw base.
2. Place the mitre saw on the mounting bars and
line up the holes in the mitre saw base with the
slots on the mounting bars.
3. Feed a bolt through the bottom of the mounting bar then through the
base of the mitre saw.
4. Slide a washer and then a spring washer onto the
bolt and fasten it with a hex nut.
5. Repeat steps 3 and 4 for the other 3 holes on the
mitre saw base.
ASSEMBLY
WARNING!
Only use a mitre saw that has 4 fixing holes (1 in each corner of the
base) on this stand. If the mitre saw does not meet this requirement, do not use it
with this stand as the mitre saw cannot be properly secured. Failure to follow this
direction may result in damage to property and/or personal injury.
WARNING!
During operation and before starting a new job, ensure that all screws
and nuts are tightened correctly and securely.