page 8
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from
motor housing to come through holes in
midde of fitter plate. Twist fitter plate to lock.
Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter
plate and partially loosen the other 2 screws.
Connect
WHITE
wire from LED light kit to
WHITE
wire from motor housing. Connect
BLACK
wire from LED light kit to
BLACK
(or
BLUE
) wire from motor housing. Be sure that
molex connections snap together
completely.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Align grooves on shade with nodules on
inside of LED light kit and push up gently on
shade. Twist shade to the RIGHT (clockwise)
until shade locks into place. Pull down VERY
GENTLY on shade to make sure that shade is
secure.
If you do NOT wish to use the light kit
,
locate
slots on metal cover and align with nodules
inside
LED light kit
. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
until
it no longer turns.
WARNING
: Metal cover will be HOT if light is
left on.
LED light kit
motor housing
motor housing
fitter plate
LED light kit
molex
connections
motor housing
nodules
shade
grooves
metal cover
grooves
motor plate
nodules
9. Light Kit Assembly (Optional).
