page 6
With wider opening facing up, place housing ring over
top
of motor housing. Then, push housing ring down
past top edge of motor housing.
Lift motor housing to mounting plate and then hang
motor housing on j-hook on underside of mounting
plate. (Use one of the
non-slotted
holes on the rim of the
motor housing to do so.) This will allow motor housing to
hang out of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once you
are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw
. Test safety cable by
pulling on loose end of cable with pliers. If the safety cable
slips, the loop must be adjusted smaller.
Extra cable slack
can be left in ceiling area.
5. Preparation for Wiring.
6. Wiring.
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to in the diagram to the right, please
use a qualified electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
Once motor housing has been temporarily hung
on the j-hook on the mounting plate,
WIRE THE
RECEIVER
with wire connectors provided
as shown
in diagram at right.
Tip
: While you are wiring, keep in mind that wires
must not obstruct receiver.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into mounting
plate and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside
of mounting plate.
wood
joist
safety
cable
loop
wood screw
and washer
safety
cable
non-slotted
hole
j-hook
motor housing
housing ring
(wiring for receiver)
ground (green
or bare)
white supply wire
black supply wire
from receiver
black AC IN L
AC IN N
white
white
ground (green or bare)
ground (green/yellow)
antenna
from ceiling
receiver
black
*
ground (green)
black
blue
white
white
pink
yellow
yellow
gray
gray
from
receiver
pink
from fan
