5. Fan Assembly.
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
page 5
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Slide hanging ball off of the downrod. [
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod. [
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely.
[
Refer to
diagram 2
.
]
Slide yoke cover, canopy cover and canopy over
downrod. [
Refer to
diagram 3
.
] (
Note
: Canopy cover
must be turned with smooth side
toward
the motor
housing.)
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod--the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely. [
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
set screw
hanging ball
stop pin
diagram 2
diagram 1
diagram 3
diagram 4
canopy
set screw hole
hanging ball
stop pin
motor
housing
downrod
electrical wiring
safety cable
yoke set screw
and nut
pin
clip
canopy
canopy cover
downrod
yoke
cover
yoke
cover
motor
housing
pin
clip
