hanging bracket
star washers
outlet box screws
flat washers
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position.
WARNING
: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be sure
the outlet box is securely attached to the building
structure and can support the full weight of the fan.
Ensure outlet box is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved
outlet box. Failure to do so can result in serious injury.
CAUTION
: Be sure outlet box is grounded properly and
that a ground wire (
GREEN
or bare) is present.
Install hanging bracket to outlet box using outlet
box screws provided (or original outlet box screws),
star washers and flat washers provided with new or
original outlet box.
*
If installing on a vaulted ceiling,
face opening of hanging bracket towards high point
of ceiling. Arrange electrical wiring around the back
of the hanging bracket and away from the bracket
opening.
*Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this
will support the fan.
4. Hanging Bracket Installation.
page 4
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 10 feet (3.048m) from the floor and
30in. (76cm) from any wall or obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing a
longer downrod (0.5in./1.27cm diameter). Other
installation, such as
flushmount
, is
not
available
for this fan.
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
Vaulted ceiling
angle is not to
exceed 25 degrees.
downrod
installation
flushmount
installation
12f
t - 20f
t
12ft - 20ft
(3.66m - 6.1m)
(3.66m - 6.1m)
10 feet
(3.048m)
(76cm)
30
inches
blade edge
