page 10
10. Automated Learning Process./Activating Code.
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter. Install one 12-volt battery
(included).
Since this fan comes with an LED light kit, the
dimmer switch (labeled
ON
and
D
) has been
pre-set to the "ON" position (
ON
). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (
D
).
Restore electrical power.
Turn power off again for
at least 5 seconds
and then turn power back on.
Within 60 seconds of restoring the power, press and
hold the fan
SET
button for 5 seconds or until light
blinks twice. Then replace the battery cover.
NOTE:
Battery is not rechargeable. Remove
batteries with low or no charge and dispose of
properly.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is best
to check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep
battery away from children.
WARNING
: Non-rechargeable batteries are not to
be recharged; Do not mix different types of
batteries such as alkaline, carbon-zinc, or
rechargeable batteries; Do not mix old and new
batteries; Batteries are to be inserted with the
correct polarity; Exhausted batteries are to be
removed from the product.
battery
cover
battery
SET
dimmer
switch
REMOTE CONTROL
(
back
)
REMOTE CONTROL
(
front
)
I
I I
IV
VI
I I I
V
